Zhengzhou Batte has many years of experience in the manufacture of melt pumps. It provides melt pump equipment including: standard extruder melt pump, rubber melt pump, reactor melt pump, etc. Each melt pump has a prescribed higher working pressure. If this pressure is exceeded, serious damage may occur. A typical situation is a high discharge pressure caused by a "cold start", which means that the downstream adapter, screen changer or die is still too cold, or solid (unmelted) material is blocking the way. To prevent the melt pump from overpressure, the melt pressure sensor should be installed directly before and after the melt pump. Melt pressure sensors are usually connected to a control system with dual alarm functions (warning and shutdown). As a standard, Zhengzhou Batte integrated the pressure sensor thread into the housing of the melt pump. Therefore, no additional holes are required in the adapter before or after the melt pump.
Zhengzhou Batte provides melt pumps from a technical point of view, which can be applied to all extrusion processes. In recent years, domestic polymer gear melt pumps are commonly used in sheet extrusion (PET, PP, PE, PS, HIPS), compounding, pelletizing (wire and underwater), coating, pipe, profile, blown film and cast film Squeeze out. Melt pumps can also be used in the production of wires, cables, textiles (fibers and non-woven fabrics), EVA, hot melt adhesives and PSA.
