Location:Home > FAQ

How to melt pump equipment for routine inspection

 We all know to fire security prevention against safety, so if make the melt pump equipment routine maintenance and inspection to ensure safety?
First, before each run, check the wire line to see if there is any breakage, voltage is stable.
Second, before operation, check whether there is residual liquid inside the equipment. If you have, whether need to troubleshoot processing residue left by the last time, if not, what is need to understand, to inform the factory personnel to obtain technical support.
Third, after each run, according to the steps closing device, and check whether there is residual liquid inside the equipment.
Fourth, after the equipment operation, check whether the power switch is closed, the lines are in good condition without damage, if there is any breakage, need to repair in time, so as to avoid leakage cause potential safety hazard.

Inquiry Us

Melt pump is your extruder’s best friend

CONTACT US

  • Tel: +86 371 67991755
  • E-mail: sales@battemachinery.com
  • whatsapp: +86 158 38331071
  • After-sales Tel: +86 371 67997677 / 67997877
  • Mob: +86 15838331071
  • Address: No.11 Changchun Road, High & New Technology Development Zone, Zhengzhou, China.